Resin Attachment ZP2 Series – Giác Hút Chân Không SMC

Note 1: The “■” in the model numbers in this table indicates the attachment material.
Note 2: The “□” in the applicable pads in this table indicates the pad material.

• This attachment can only be assembled onto the manufacturer’s standard bellows pad.
• When the attachment is made of conductive PEEK, use conductive material for the pad.
• Before using the attachment, make sure to clean it.
• This product has not been cleaned. If used in the condition in which it was shipped, residual material or marks may be left on the workpiece. Clean properly before using. Contact the manufacturer’s support center if you have any questions.
• The part of the product which contacts with the workpiece is made of resin and may suffer greater vacuum pressure leakage during suction than the general rubber pad. Therefore, maintain as large a flow rate as possible in order to minimize drops in pressure due to leakage.
• Cannot be used for vacuum retention.
• Make sure to evaluate the product to ensure it can be used.
• If having contact with hard materials is a problem, refrain from using this product.